First try at an acrylic case build. Had to replace the former Aluminum Fabrication due to a dead Power Supply, and a love of rivets in the fabrication process :) This one, with a few upgrades, runs like a beast! With Corsair's H5 SF Small Form Factor AIO cooler for ITX builds, CPU never hits mid-60'C, and usually runs around 55'C under load @ 3.5 GHz. GPU with an extra 80mm fan forcing air into cooling fan has only broken 60'C under load for hours once. Both idle in low-mid 30's. Framerates for slightly dated games on all max settings usual steers well above 100 fps. Later DX11 games with high graphical demands usually hold 60 fps on ultra, but have to be dialed back on settings to keep a 100+ fps to utilize G-sync, and avoid action stutter on the 144MHz 1080p monitor. The build took a little over a week on evenings and a single weekend marathon after I figured out a few design issues. I originally made a draft design of my components on Tindercad. After creating models of all parts, I played with orientations to make the tightest functioning fit.