WOW! Gorgeous!!! I'm going to upgrade my Z170 skylake build like this ASAP!
Yep, first build. About 4 hours.
Yes, it does!
Thanks for great advice!
Hey Bigchorizo, if you wanna see a stunning build with the AIO cooler in top watch @joaocmfcm's build! at: https://pcpartpicker.com/b/rVxYcf
Ahh oke! Thanks for information!
Btw, why did you removed your drive caddy cover on the right? Was there no other place that would fit the Hue+?
thanks, and so do you! If they see your build they will realize!!
Yes, you can see my build at: http://pcpartpicker.com/b/BPwV3C
For me the smaller design is just perfect, i love it! But you are 100% right that it's a reall tight fit.
Thanks and I will certainly do my best to improve my cable management!
Idle (5% load right now):
The case quality is superb and its really easy to install things in! Although the case is relatively small for an atx version. so it's a tight fit.
Clean Build!! I have the same case and the Hue+, corsair fans and sexy looking sleeved cables are on my wishlist! Good to see its so damn gorgeous!
Hey Golgoy, I have the same case.
I have tried to mount my AIO cooler in top but it doesn't fit because of my RAM. There is only 4,6 cm (1,8 in) of space.
Thank you Sawdog!!
Thanks for advice jkarll! I will definitely find a solution to hide my cables!
Thanks! I have tried to mount my AIO cooler in top but it doesn't fit because of my RAM. There is only 4,6 cm (1,8 in) of space.
It is a wonderful case and I really love the large side panel (slightly tinted). The quality is superb. When I open the side panel it vibrates a bit, but that is because of the strong magnets.
There was enough room for cable management at the back. The hole in the CPU cover is a bit too far to the left, in my opinion, so that the cables cannot go straight down. Air Flow is good and the dust filters are easy to remove. The front panel is quite hard to remove.
Overall it’s an excellent case with plenty of opportunities for expansion.
The Phanteks Enthoo Pro M is also an perfect choice!