Thanks for the compliments. Just to update your "questions", fan lights ain't bright at all (set to medium brightness), while i'm sharing the desk with my wife and her pc is right beside the monitor. We have a cramp area, lol. Will update her setup after receiving her new GPU replacement.
I advice to sync with Mystic MSI rgb software to deliver different outcome rather than aorus software from the board
It’s still there. I’ve relocate the position only. Ones under the top inner, ones outer btm outer.
Yes it does. You may adjust from aorus rgb fusion. Only applicable for solid colors per address.
Anytime mate, cheers
There you go
Coolermaster led strip. Only plays solid/static addressable colors.
It was 2 in take and 2 exhaust. 3 exhaust was for photo snaps. XD
I’ll switch them and work on it soon. Thanks for the advice again, heading off now. See you soon.
GPU fan at 60% load with a decent numbers of temp on going rather than leaving it factory auto. Shall compare with the in let and out let of the fans by this weekend. Cheers B)
Currently GPU idles at 39, while lowest at 35. And while under load at 68.
Yeap will swap the air flow maybe by the weekends. And see how much difference is the temp difference. Basically the front fans were meant for aesthetics only.
What do you suggest? Top and rear exhaust and intake for the front? B)
Am not sure if it’s good for video editing not. And the cables were from mdpc-x. High quality cables
Idling at 55 Celsius while 68 Celsius under load.
Regardless about how it mounts. I’m happy which I gain aesthetic and a 10degrees difference from the previous case.
Current GPU heat at 68degrees Celsius full load while gaming. I remember with the standard setup it would be 64-65degrees Celsius if I am not wrong. I would give in for the aesthetic over 3 - 5 degrees of Celsius difference.
All done. Cheers
No hassle installing Cablemod vertical mount, take note at the GPU stand up without sag. Great product.
No doubts I'm very fresh and new to pcpartpicker. And this was my first built too.
How I wish only “A cpu runs itself” without boards or rams and etc XD
Will amend the part list soon
Yes I would do so
Yes you’re right I will need to amend the post
Corsair triple pack LL120MM. CPU cooler with Thermaltake ARGB 120MM
Soon to be edited thanks for the highlight
Yes you’re right. Before switching to H500, GPU was running at 78 degrees Celsius. I’ve installed vertically using cablemod expansion which is away from the glass door, it would not trouble the GPU at all, highly recommended for this. Regarding about the fans setup, which previously was negative and it was for photos capturing only. Whereas CPU is running on AIO, pretty decent temp on gaming though. And there’s only a placement for top fans setting except you mod the case itself which I am not doing it.
Yeah. I saw that faulty and I’m gonna edit the part list again.